AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Ccnp switch packet tracer labs11/11/2022 Set the adminstrative domain VTP version number Version Set the adminstrative domain to VTP version Password Set the password for the VTP administrative domain Switch(config)#vtp ?ĭomain Set the name of the VTP administrative domain. VTP domain can be configured an propagated through switches. VTP v1 and VTP v2 are supported in Packet Tracer in client, server, transparent mode on Catalyst switches. Voice VLAN configuration is supported on Catalyst switches Switch(config-if)#switchport voice vlan ?ġ.4 Configure and verify trunking VTPv1, VTPv2, VTPv3, VTP pruning Normal VLAN (1 to 1005) and extended VLAN range (1006 to 4094) are supported on Catalyst 2960. Please consult userĭocumentation for configuring VTP/VLAN in config mode. % Warning: It is recommended to configure VLAN from config mode,Īs VLAN database mode is being deprecated. VLAN have now to be configured from config mode (configure terminal). However, configuring VLAN in the vlan database mode is deprecated. VLAN database is supported in Packet Tracer on Catalyt 3650-24PS Multilayer switch. UDLD protocol is not supported in Packet Tracer.ġ.3 Configure and verify VLANs Access portsĪccess port configuration is supported in Packet Tracer with switchport mode access & switchport access vlan commands VLAN database Transmit Enable LLDP transmission on interface Receive Enable LLDP reception on interface Switch(config)#interface fastEthernet 0/1 (W) WLAN Access Point, (P) Repeater, (S) Station, (O) Otherĭevice ID Local Intf Hold-time Capability Port ID (R) Router, (B) Bridge, (T) Telephone, (C) DOCSIS Cable Device Packet Tracer LLDP capabilities Switch#show lldp neighbors Router(config)#interface gigabitEthernet 0/0 S - Switch, H - Host, I - IGMP, r - Repeater, P - Phoneĭevice ID Local Intrfce Holdtme Capability Platform Port ID Packet Tracer CDP capabilities Router#show cdp neighborsĬapability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge Both protocols can be enabled or disabled globally or per interface. Switch(config)#mac address-table static ?Įrr-disable is not supported in Packet Tracer.ġ.2 Configure and verify Layer 2 protocols CDP, LLDPĬDP and LLDP discovery protocols are both supported in Packet Tracer 7.2 on all Cisco Catalyst switches and ISR routers emulated devices. Mac address table can be reviewed globally, by interface, for static or dynamic entries only. Static mac address configuration, mac addresstable lookup, and mac address table clearing are supported in Packet Tracer. SDM templates are not supported in Packet Tracer Managing MAC address table 1.1 Configure and verify switch administration SDM templates
0 Comments
Read More
Leave a Reply. |